tekin-rs-gen2Tekin has announced the new RS Gen2 brushless speed control. The RS Gen2 delivers a programmable high-voltage BEC, an EZ Access Port for HotWire communication and data logging capabilities in a small sized package. Rated for 8.5T motors and higher, the Gen2 is ideal for both experienced and new racers.

Ultra-smooth and precise throttle and braking control
Compatible with sensored/sensorless brushless/brushed motors
Easily access programming
Data logging capability
High Voltage programmable BEC
EZ Access HotWire programming port
HotWire PC interface for advanced programming and updating
D2: Dual Drive Mode Technology
On-Board temperature indicator
HDAC: High Density Copper PCBs
Sensor plug for precise commutation with all motors
Gold-plated solder posts for easy wire replacement
Self Test Diagnostics and Factory Reset
Pit Tune Mode
DGF2: Digital Glitch Filtering V2
QuickTune™ Programming
One-Touch radio Calibration

High Voltage BEC (6V/7.4V)*
Drag Brake (13 steps)
Brake/Reverse Strength (13 steps)
Current Limiter (none + 12 steps)
Neutral Width (13 steps)
Timing Profiles (5 preset – 2 custom*)
Adjustable Throttle and Brake Minimums
Custom Throttle Curves
Motor/Reverse Type: Brushless, Brushed, No Rev, Rev Delay
Voltage Cutoffs (none, 2S, 3S, Custom)
Timing Boost and Turbo when used with Hotwire
ROAR Race Spec “Blinky” Mode
Save, Load and Share custom set-up files
Extensive Tuning via Tekin HotWire PC Interface

*Requires HotWire available seperately

Source: Tekin

Tagged with →  
Share →

Leave a Reply

Your email address will not be published. Required fields are marked *